新建网页 3
Black Resin DIY 20 Cube Wardrobe
No more to worry about the smell and move of the wooden wardrobe. Here comes a dismountable DIY wardrobe. You can hang your clothes and also storage things. Every piece of board is made of environmental protection resin and no pollution or stimulation. The buckles are made of ABS plastic, wear-resisting and with long service life. The frames are made of steel, stronger and with better bearing capacity.

Parameters:
Material resin, ABS plastic, steel frame
Dimension L*W*H= 58inch*18.5inch*72inch
Detail and attachments pictures:

Assemble steps:
1. Assemble the lowest layer.

Note: The directions of the forward buckles should be the same. So are the back buckles.
2. Assemble the left, middle, right boards and back boards.
3. Assemble the second and the third layer.

Note: There are no layers in the middle two rows of cubes.

4. Assemble all left, middle, right boards and all back boards.

5. Put in two clothes hangers.

6. Assemble all 20 doors.

7. Put the magnets in the buckles (the left two rows-- on the right down side, the right two rows-- on the left down side).

8. Tie two up and down doors together with the straps.

9. Tap every buckle to make it tight so that the wardrobe can be firm.

Packing list:

---60* corner link (buckle)

---20* (35cm*35cm) black board-- back

---20* (35cm*35cm) white board with hole --door

---41* (35cm*45cm) board—layer, left, middle, right

---2* clothes hanger

---1* wooden hammer—tap on every corner link to make the wardrobe firm and tight
Item included:
1 set of black resin DIY 20 cube wardrobe (251205)