Sign in or register

My Techtongda

 

   
Screen Printing> Chemicals & Inks> Chemicals>
008417:Emulsion Remover powder - 100g
Unit:
Bottle
UPC:
MPN:
Weight:
0.10kg
     

Similar products

008000:Screen Frame Adhesive - 1kg

008401:Solvent Emulsion 950g + 4g / set

008450:Pallet Adhesive - 0.5kg

011032:Ink Thinner 500ml/Bottle

008512:All Mesh Prep Degreaser 200g Per Bottle

Emulsion Remover powder
 

It’s used to remove the emulsion layer of the stencil for recycle use. It should not be permitted to dry on the surface of the screen. It will become virtually impossible to remove if allowed to dry. Repeated rinsing will result in excess waste water that must be disposed of as a regulated waste and will not significantly improve the situation.

 

Working Instruction

  • a. Add the powder in some cold water and stir evenly until the powder has fully dissolved.

  • b. Clean ink and filler off the mesh.

  • c. Apply some dissolved solution onto both sides of stencil, soaked for 2-5 minutes, then brush the stencil until the emulsion has been dissolved.

  • Rinse off with flush water.

Parameters

  • Net weight: 0.22Lb / 100g

  • Storage: Seal preservation in cool and dry place.

Note

  • 100g powder can mix with 4-5L cold water. But if it’s difficult to remove the emulsion, please reduce the dosage of water; in contrast, please add the dosage of water.

  • Please flush with water in case of accidental skin contact.

  • Please ware respirator while using if you can’t stand its pungent smell.

无标题文档

About Us

Copyright techtongda365.com All Rights Reserved