|
1.Comparing the
cables/wires’ diameters with the feeding holes on the
machine, feeding the cables/wires one piece at one time.
Before feeding the cables/wires, please cut off the head of
the cables/wires, to avoid gaps caused to the blades.
2.On the output side, if the cuts on the cables/wires are
too deep, please check below points:
1) Please adjust the handles on the input side, screw down
or loose them. (M12 handles)
2) Check whether the cables/wires on the right position as
you feeding them.
3) Make sure the blades are sharp, if not, polish them with
the oil stone.
3.On the output side, if see the plastic (PVC) has been
stripped, but the copper wires can not been disgorged,
please check below 4 points:
1) polish the axis of the upside with the oil stone.
2) Check whether the springs are loose, if yes, screw down
to make them tighten.
3) The diameter of the cables/wires are too small, please
adjust the space between the two axises to 0.3-0.6mm.
4) If the cables/wires you want to strip are hot, also can
not get the copper wires stripped out.
4.If the cables/wires were blocked in the axises, please
check below points:
1) If the springs on the press wheels are too tight, loose
them.
2) There are too much oil on the cables/wires, please wipe
it.
5.If see the blades tilted :
1) Check whether the center adjuster was loosed.
2) centering adjustment and adjust the screws of two sides
of it.
Make sure the cables/wires’ diameter are similar with the
feeding holes, large cables/wires in large feeding holes,
small cables/wires in small feeding holes, flat cables/wires
in flat feeding holes.
|
