ASC365 Plotter/Cutter Installation Instruction
Don't use USB and serial port at same time
USB port setting

1- Connect plotter USB port and computer USB port. Always use same USB port of computer, DO NOT change
USB port every time use plotter, or you may make setting every time!
2- Turn on plotter, download USB driver WIN win7-32/Vista32/XP/2000 .

3- Install USB driver, Double click SETUP, Click INSTALL

　

4- Click OK

　

　

5- Port setting

1) Click start. 2)Right click My Computer. 3)Click Properties

4)Click Hardware. 5)Click Device Manger
6) Click + (Ports)
7)Double click USB(COM4)
The port(COM4) is uncertain, sometimes COM3, COM5...., We need adjusting to com1 to com3, cause of Artcut software only supports COM1 - COM3
9) Click Port Settings.
10)Set Flow control "Xon/Xoff"
11) Click Advanced
12) choose port
*13) Click COM3
14) Click OK
　

* You could choose COM1,COM2 or COM3.

COM1->Artcut-COM1
COM2->Artcut-COM2
COM3->Artcut-USB

　

Close all windows, check the setting again, should be like this.