Step by Step to Make Button by New Professional Button Maker
|
Step by Step to Make Button by New Professional Button Maker |
||
| 1. When making the metal back pin button(37mm,44mm,58mm and 75mm), a gasket need to be put in B mould. |
|
|
| 2. Rotate the mould table. |
|
|
| 3. Place a shell into A mould with the sharp edge facing downward. |
|
|
| 4. Place the graphic on the shell. |
|
|
| 5. Place the Mylar on top of the graphic. |
|
|
| 6. Rotate the mould table until the upper mould is facing to A mould. |
|
|
| 7. Hold the button making
machine by one hand and pull the handle down. |
|
|
| 8. Place a pinned back into B mould with the sharp edge facing up. |
|
|
| 9. Rotate the mould table until the upper mould is facing to A mould. |
|
|
| 10. Pull the handle down as far as it will go and raise it back up to its rest position. |
|
|
| 11. Rotate the mould table again to remove the finished button. |
|
|
|
|
||
|
Youtube Video Guide |
|
|