dispensing machine controller TC5520

Description:

1:system

2:run

3:alarm

4:X axis

5:Y axis

6:delete

　

 7:exis

8:confirm

9:start

10:stop

11:page up

12:page down

　

Feature:

1:Boot interface to download
2:Fill out a form equation editor
3:The power supply reverse connect protection
4:Output short protection

Technical parameters:

Technical indicators name

 Index value Name of a program's instructions
working voltage
 +/-24CDC end
maximum power consumption
 40W Point movement
Operating temperature 0-50 straight line motion
Operating humidity
 0-90% absolute motion
File storage lines

 480 Identify your Coordinates
Program file number

 20 delayed
Controlled Axes X/Y JPA JumP Absolute
Maximum data unit

 0.001mm conditional jump
maximum size +/-99999.999mm circulation
output pulse frequency
 150KHZ output
Pulse output form

 Single pulse polarity direction

 Back to the mechanical zero
input-output channel 16/8 subroutine calls
Output channel load

 100MA The procedure to start
isolation voltage
 2500V The procedure to end

Buttons define

button explain
 remark
Reuse key, is used to select the corresponding function

 multifunction key
Number keys 1 2. Editing for number keys, manual interface, long press 1 or 2, corresponding to the X/Y coordinates can be cleared for the shaft reference point data, the default is 0, the axis reference point data can be set up under the parameter - system - control interface

 multifunction key
Number keys 1 2. Editing for number keys 　
The number keys 1 2. Editing for number keys, manual interface, long press 0, the interface is counting on the workpiece zero

 　
When editing, used to fill in the negative

 　
When editing, used to fill in the decimal data

 　
Currently in the program editor interface, long press the F key, is used for the emptying of the current application, create a new program without the file name under the manual interface, long press the F key, can use the number keys 1 to 4 OUT1 - OU4 control output

 multifunction key
Automatic and manual interface, is used to increase or decrease or reduce the current speed F worth ratio; Program under the edit page for instructions of the fluctuation cycle of looking for; The rest of the interface under page for page up and down

 multifunction key
Under part of the interface, select the data or file, according to the prompt for confirmation or delete

 　
After the level into a few pages, used to return to the interface at the next higher level

 　
Manual automatic interface, for X axis and install the control key, back to the zero mode, can control motor and reversing back to zero in two ways, the rest of the interface used to fill in the data under the cursor, move to a place you can modify the current location data

 multifunction key
Manual automatic interface, and reverse loading for the Y axis control keys, the rest of the interface used to fill in the data under the cursor, move to a place you can modify the current location data

 multifunction key
User program startup suspended, under the automatic interface

 　

If you are a mechanical fan, like your own research and development innovation, our products will make you satisfied.

Item included:

017402   dispensing machine controller TC5520