220V Low Temperature Cooling Liquid Circulator 6L |
|
Introduction |
|
||||
Parameter Model: DC-0506 Volume: 6L Operating ambient temperature: 5℃-30℃ Relative maximum humidity: 80% Temperature range: -5℃-100℃ Temperature fluctuation: ±0.1℃ Internal material: 304 stainless steel Opening Size: 6''×4.3'' External dimensions: 16''×19''×33'' Circulating pump flow: 8L/min Net weight: 45kg(99lb) Voltage: 220V/50Hz Instruction 1. Remove the package, clean the working platform 2. Add liquid medium into tank, make the medium level 30mm(1.18'') lower than the working platform 3. Connecting circulating pump inlet and outlet pipe ①When the pump does't need to carry out the outer-circulation, just need to use hose to connect the inlet pipe with the outlet pipe ②When the pump is used for the outer circulation of the constant temperature liquid, please use 1 pipe to connect the outlet pipe of the pump with the inlet pipe of the container outside of the tank. Use another 1 pipe to connect the inlet pipe of the pump with the outlet pipe of the container outside of the tank. Precautions 1. Before using the tank, please must add liquid medium, otherwise, it will damage the heater.The medium level must lower than the platform. 2. The selection of the liquid medium in the tank shall be in accordance with the following principles: A. When the operating temperature is 5℃-85℃, the liquid medium usually use water B. When the operature temperature is 85℃-95℃, the liquid medium can use 15% glycerin-water solution C. When the operature temperature is lower than 5℃, the liquid medium is generally alcohol or freeing liquid 3. To improve the service life of the refrigetation system, the system adopt startup protection. Once turn off the refriheration system, it will need 10-20minutes' space to turn on the switch again(such as turn on the switch to start the compressor in less than 10 minutes from the last operation, it is a normal phenomenon that the system will not start) 4. Power supply should be greater than the total power of the machine, the power supply must have a good grounding device. 5. The machine should be placed in a dry and ventilated place. 6. When the working temperature is very low, please do not put your hands into the tank to avoid frostbite. 7. Cut off power supply when finishing working. |
Items included: 1 set of Low Temperature Cooling Maching (020041)
|