Two mode: work bench and scaffold mode. Donot load more than 500 pounds. Donot use scaffold with legs fully extended. Donot stand on the work table in the workbench mode.

The tool tray is designed for hold hand tools ,fasteners, and standard paint cans. The MDF work surface provides a robust surface for hammering and woodworking.

The ruler and protractor graphics on the MDF surface make it possible for accurate measurement.

Storage mode for workbench mode.

Rest the bench on either handle. Squeeze the locking paddles together. Rotate both sets of legs approx. 90° until scaffold desk is the top surface. The legs will lock into place when they rotate into position. Gently turn scaffold upright onto a stable, level surface. Do not use scaffold with legs fully extended.

Notice: Gusset brace must be attached for safety in the scaffold mode.

Workbench and scaffold mode.

Unlock all gussets braces by pressing the snap buttons, removing the braces from the leg bolt and folding them back into storage mode. Rest the bench in either handle. Squeeze the locking paddles together and rotate both sets of legs approx. 180° until the MDF is the top surface. The legs will lock into place when they rotate into position. Push the snap buttons on the side of each leg and pull the telescoping leg out and extend them to the bench height. When the legs are fully extended, the snaps will be into place. Gently turn scaffold upright onto a stable, level surface. Do not use scaffold with legs fully extended.

1*Universal detachable woodworking Work Bench with American socket