Non-Dismantle Fuel Injector Cleaner
1¡¢Generally speaking, inlet hose is bigger, return hose is samaller£»
2¡¢There is always a filter connected in the inlet hose side, and a buffer in the return side£»
3¡¢There is arrow on the hose to show the fuel flow direction
¡¡
Parts drawing:
Check fuel injection style, throttle or EFI:
To EFI
style:
1¡¢Find out the fuel return
hose, disconnect it and plug it with suitable adaptor£»
2¡¢Find out the fuel inlet hose, disconnect it and connect it with the
outlet hose of the cleaner with proper adaptor£»
3¡¢Connect the outlet and return hose of the fuel tank, and open the tank
cover; if there is not return hose, please move the fuse of the fuel
pump so that the pump will not work£»
4¡¢Charge the cleaning fluid into the tank of the cleaner£»
5¡¢Connect the air source power to the air port of the cleaner, adjust
its pressure 40-50PSI£»
6¡¢Check all connect point to make sure there is not leakage£»
7¡¢Start the engine to clean the fuel system
To the throttle style system :
The way of connection is the same,
just adjust the pressure of the air source 1-5PSI.
The way to identify the inlet and return hose:
1.Generally speaking, inlet hose is bigger, return hose is samaller;
2.There is always a filter connected in the inlet hose side, and a
buffer in the return side;
3.There is arrow on the hose to show the fuel flow direction
4.Wear protective glasses before operation .observe the joint whether
there is oil leak.if there is,please start to work after remove the
fault.as a result of losses caused by human negligence,the user
undertakes the responsibility.
NOTE:
To the throttle style system, the way of
connection is the same, just adjust the pressure of the air source
1-5PSI
Item Included:(148021)
1*Fuel Injector Cleaner with plastic kit