Thermostatic Water Bath
Electrothermal constant
temperature bath is widely used in distilling drying inspissation and
infuse chemical or life-form
This product is flume mode , the biggest aperture is 12 cm , has four
ring and one cover every hole. The inner is made of import stainless
steel , the crust is made of high grade sheet and sprinkle with plastic
. galvanothermy-pipe is equipped in water , heat up fast and save power,
and also has the digital constant temperature set, adjust range from
normal temperature to 100 degree, with error 1 degree
Operating Methods
1¡¢Set
temperature: use of water in the pot must be added, then power on,
Temperature Setting
Press SET key to switch to the temperature setting mode£¬the
digit twinkles indicate you could change the value by pressing up key to
increase or down key to decrease. Press down constantly to increase or
decrease continuously to the value you need. Press the SET key to exit
the setting mode when finish setting.
2¡¢Parameter
SettingSc: press down the SET key for 3 seconds to switch into the inner
parameter setting mode. It displays the Sc means the error between the
measured value and the actual value. Press the setting key it shows the
twinkling default value 0.0£¬you
could change the value by press up or down key(the same operation as
below) range:-9.9~9.0
(1) To ensure security, use when connected to the ground.
(2) is strictly prohibited without water, dry.
(3) does not work, should cut off the power, to prevent accidents.
