| Hand edger Manual lens edger |
|
|
Operation
When this machine is to be used, connect the hose
with the adaptor of the lower water can. The place the lower water can onto the
bottom of the machine (the water can run out either in the front or at the back)
and lead the drain pipe to the sewer tunnel.
Place the upper water can on the top of the machine and let in the clean water. When the machine is used for the first time, take the sponge out from under the water valve, put it into the water, press it with your hand and the put it back in its original place after it absorbs enough water. Open the water valve and let the water drip at 80-100 drops a minute. Then turn on the switch. The machine is ready to be used. If Model W
grinding wheel is chosen, the right side will be rough ground ,and the left side
fine ground. When Model WV grinding wheel is chosen the result with be the same,
but there is also a V-shaped slot to refine the lens When the grinding wheel has been used for a
period of time, grinding fatigue will appear (failing to grind in). In this
case, use the oilstone stick to recondition the wheel. While this is being done,
open the water valve Unwrap the machine (From the Package)
1)Open the carton, and take the machine wrapped in
the foamed plastics.
2)Take the machine out carefully and place it on a big enough and quite stable desk.กก Safety Precious
Don't use this machine for any other purpose than
hand-grinding the edge of lens
While the machine is working, don't touch the grinding wheel to avoid getting injured Don't place the machine i high temperature or leave it exposed to strong sunlight. If the machine is left idle for a period of time, please remove the plug out of the wall socket. |
|
Item included: Hand edger Manual lens edger (153003) | |||||||||
|
