Stainless Steel Wheat Grass Hand Juicer

Assembly instructions:

1.Securely clamp the juicer body to the edge of a table or counter top. Make sure the rubber Foot Protector is positioned on the juicer body foot to provent the clampling surface should not exceed 3.8cm.

2.Insert the screen completely into the Juicer Body.

3.Position the Screen completely into the Juicer body.

4.Position the Auger Retalner on the Juicer body,until the end of the auger protrudes from he middle of the auger retainer.

5.Secre the auger retainer to the juicer body using the two thumbscrews with cap washers.

6.Install the Handly onto the end of the auger ,securing with the handle thumbscrew with cap washer.

7.Screw the pulp regulator onto the end of the juicer body.

Disassembly instructions:

1.Remove the handle thumbscrew with cap washer and remove the handle from the auger.

2.Completely remove the two thumbscrews with cap washer and take off the auger retaier.

3.Remove the auger from the juicer body.

4.Slide the screen out from the juicer body.

5.Tuming couner-clockwise,remove the pulp regulator.

6.Remove the rubber foot protector.

Cleanig instructions:

Before using for the first time,you must completely disassemble the juicer and thoroughly clean all parts with hot water and dish detergent,rinse wth clean water and dry thoroughly.

Do not clean in a dishwasher.

Stainless Steel Wheat Grass Hand Juicer X 1