新建网页 1 Hydraulic Pressure Test Kit Test 新建网页 1 新建网页 1 新建网页 2 新建网页 1

220V Auto Bearing Heating Machine

This kind of machine widely used in the Bearing ,Gear ,Bushing ect . By heating is the product expansion, to the needs of the assembly .

Specification:

Item Size

ELDC-1


Power

220V 1KVA

Electrode Size

 40MM

Bearing inner diameter

 20-100MM (3 Pieces to choose )


largest diameter

 150MM

Maximum width

 60MM
Highest Temperature 270 Degree
Time 999s
Insulation device
yes

　
Item Details:

Note:
1.The machine automatically detects the probe, without probe will not start;
2.It is strictly prohibited without heating shaft while initiating host;
3.Heating the workpiece should try to choose a larger heating shaft, in order to improve work efficiency;
4.Bearing maximum temperature not exceeding 120 ℃;
5.Remove the workpiece CAUTION HOT prevent burns;
6.Do not set the probe on the workpiece long to extend the life of the probe.
Operation Explanation:

1.Upon request connect the power, Host automatic detection probe, ambient temperature, and simultaneously display the ambient temperature;

2.Press the function button to select the temperature or time control, for adjusting the temperature or time, press the up or down button, select the appropriate parameter (when the thermostat, the magnetic probe adsorbed on the outer side of the bearing inner ring of the strange inner bearing The maximum heating temperature should not exceed 120 ℃;

3.Press the start button, the host starts the workpiece heating. Host automatically stop heating the workpiece automatic demagnetization when reach the set time. When the thermostat when it reaches the set temperature, the workpiece in a constant state. Needed installation, press the stop button.

4.Remove the workpiece can be installed.

5.Heating the same workpiece, use time control, please remember the last automatic heating time required.

Item Included:

  • 1 Set of 220V Auto Bearing Heating Machine (200041)