Lab Pressure Pot Equipment 220V

1. The cover is equipped with a safety valve operating pressure of 0.1MPa and can withstand the pressure of the steam discharge valve 0.14Pa safe to use.

2. The outer cover is equipped with scale pressure gauge indicates the temperature of the inner black red represents the pressure, showing clear.

3. Replace the pressure relief valve from the closed 0.1Pa, exhaust and close on their own, the pressure and temperature inside the reactor is maintained at a predetermined range, when the inside air pressure at 0.1Pa, inside is the maximum temperature can reach 120 degrees.

Funtion

1. In the body of water is added some water, continuous use, must complement each disinfection of water, in order to avoid the high temperature heating wire fuse.

2. Seal the heap good article on the topic within the barrel disinfection. Then, the cover of the deflated hose is inserted into the lid and then sterilized lids close tightly, so that the upper and lower handle security agreement.

3. Heat the pick at the start of the discharge valve open position on the vertical sub, sterilizer with air-conditioning will be heated by the valve hole overflow valve hole when the gas out of the emergency, it will pick the child back into place.

Notice

1. When first time, both sides should apply some cooking oil seals to reduce friction, to facilitate the closing lid

After disinfection, the case of the gauge has returned to zero, still can not open the lid when you can open the release valve 2. Each time that outside air enters, eliminate the vacuum.

3. When using electric pressure steam sterilizer, require safety ground, do not be placed directly on wood or flammable equipment.

4. When using the sterilizer should be placed in a special sterilization chamber can not be used in a public place or a clinic, sterilization to prevent accidents caused when using a dedicated personnel to operate, the operator can not stay away from the sterilization chamber, and should pressure gauge pointer is frequently observed value immediately once found more than 0.14MPa pressure gauge pointer off the power when the exhaust valve can not, will leave the heat sterilizers.