|
Installing the driver |
|
First of all, turn on the computer,
and insert CD into the computer, then turn on the Mini cutting plotter,
the program runs by itself to finish installing. After that, wait about
15 seconds, and the plotter will as a windows device automatically add
to the printer item.
Download the driver
กก |
|
 |
|
 |
|
 |
|
 |
 |
 |
Notes:
The cutting plotter with a "real" USB interface (not USB-serial and parallel),
can achieve plug-and-pull, if pull (or shutdown) it the computer shows
as offline, plug
in (or start) the system automatically loads device and appears as
online. |
|
 |
1. Before turn on the plotter, start
the computer firstly.
2. In working, to avoid switching on or off frequently the cutting
plotter, and a short interval between switch on and off (plug and pull).
3. After turn on (plug) the plotter, wait 10 seconds, then send the
data. You would better check the equipment is online before using. If
offline, shut down or disconnect USB and start again later to
automatically connect. Do not modify the properties in computer system. |
|
 |
| 4. If it can not be online in using,
you can delete the printer. Then insert CD to re-install automatically.
If you want to completely remove the driver, you should follow these
steps: |
|
 |
|
 |
|
 |