Special note:

Lithium, rechargeable hand drill can not be installed.

The machine does not include a hand drill.

This product can be used for the diameter of 80mm, length of 600mm within a variety of round pipe, round rod. Remove thorns from the edge of the head, remove rust, stretching and polishing from chamferes, tubes and rods.

2:Especially suitable for shorter length (less than 600mm) , suitable for the traditional grinder, Angle Grinder to the head of the Burr is difficult to be removed in the standard chamfer, and the rust removal, wire drawing and polishing of the round pipe and the round rod, etc. .

3:This product is equipped with abrasive lifting platform, sandpaper mounting plate, bearing sliding track, can be adjusted according to their own needs.

4:Both sides of the fixture can be moved about 30cm, can be adjusted according to the length of the workpiece. The hand drill can be installed on both sides of the machine.　

Special note:

This machine is not a machine tool products, can not be used as finishing equipment, the installation of the need to process the pipe concentric degree can not be the same as the machine, there will be a certain deviation.