Overwrap machine 220V
This film wrapping machine (hereinafter referred to as the ACW88) unites film rolling and heating function. It is always used for cellophane, BOPP film wrapping products. Its semi automatic operation makes it a really effective machine for those manufacturers who are desperate for expansion of output. ACW88 machine was newly made in April, 2015 by our own well-trained engineer. ACW88 makes a great improvement upon the old model CW88 machine, breaks the limitation of packing product size. Thus, it can wrap nearly every size of small boxes as cigarette box, perfume box, cosmetic box, tea box and gift box. Besides, ACW88 not only breaks the limitation of products, but makes improvement on packing efficiency, increases from former 15pcs/min to 20pcs/min!
.jpg)
Notices:
|
Model |
ACW88 (standard model) |
|
Voltage and Power |
220V,50~60hz |
|
Max Packing Product Size |
≤400mm L |
|
Packing Speed |
20pcs/min (If practiced) |
|
Temperature Range |
0~300 |
|
Weight |
23KG |
|
Machine size |
450mm*310mm*370mm |
Operation
1) Be sure of that the machine is power on.
2) Hang the film on roller, ready for packing.
3) Set temperature on panel to 120~220 Celsius Degree.
4) After preheating for seconds, pull film down and wrap product with film by hand.
5) Then cut the excess film with the cutting razor attached on the roller.
6) Put it on the heating plate for wrapping.
7) Send it to another film folding machine to fold the unpacked two sides.
8) Finally, get the fully wrapped product from the folding machine.
MAINTENANCE
The job of proper maintenance is necessary for machine to work normally and prolong its life. Maintenance includes a few aspects described below:
l Power off the machine before maintaining.
l If the machine runs irregularly or makes strange noise, please cut off the power immediately and contact the manufacturer or the supplier.
l Don’t wash the machine by high pressure cleaning, which will damage the electronic device and other spare parts.
l Non-professionals should never cannibalize machine and fix it.
l Machine should never be tripped or fall down from high place.
l The machine works at most 8 hours in a day. The manufacturer is irresponsible if the user prolongs the working hour too much.
l If the machine is damaged or in problem as the user maintains the machine without the instruction in this manual, the manufacturer is irresponsible for the problems.
.jpg)
|
Breakdowns |
CAUSES |
Solutions |
|
Untidy film cutting. |
Cutting razor is becoming blunt. |
Change the cutting razor. |
|
Wrong cutting method. |
Regulate cutting operation. |
|
|
Heating Plate does not generate heat. |
Wire disconnected or power is off. |
Connect wire and power on the machine. |
|
Temperature controller failed to work. |
Check the controller or change a new one. |
|
|
Film melts. |
Heating temperature sets too high. |
Set down the temperature with controller. |
|
Heating time is too long. |
Reduce the heating time. |
|
|
Bad packing effect. |
Temperature sets too low. |
Please set temperature to the range between 120~220 Celsius Degrees. |
Details & Functions:
Insutructions
.jpg)
.jpg)
.jpg)
