 |
3. Control
Panel
LED digital tube display
panel, intuitive display of time and current, simple and
convenient operation, reading at a glance. The working time
and current can be appropriately adjusted according to the
size of the workpiece.
|
4. Support
Legs
Four
rubber support legs at the bottom, which are non-slip,
wear-resistant, good silence, can ensure the stability of
the machine, and can prevent water from entering the machine
from the bottom.
|
 |
- The output voltage of the machine
is stable, controlled in the best range, and the current
distribution is uniform, which can effectively avoid excessive
electrolysis Influence on the size of the workpiece.
- It can effectively protect the electrolyte, prolong the
service life of the electrolyte and reduce the cost.
- The current can be controlled to completely avoid the
situation of frequent fuse burning and component burning caused
by the rising current of traditional electrolysis machine.
- Select precision potentiometer, adjust current more
accurately.
- With overload, overheating protection function, longer
service life. |
|
1. Pour the electrolyte into the
electrolytic cell, and fix the electrolytic tile (cathode) by
both ends of the electrolytic cell.
2. Clamp the bracket (workpiece) with the clamp (anode), the
workpiece should be connected with copper wire hanging, put into
the electrolyte, pay attention to not contact with the
electrolytic tile.
3. Set the working time and adjust the current according to the
size of the workpiece, it is recommended to use high current to
quickly deal with the surface, and then reduce the current to
increase the brightness of the mirror.
4. After setting time is over, take out the bracket (workpiece)
and rinse it with water. |
