|
Genset Auto
controller HGM6120U Generator control Module #110123 |
 |
|
Description |
| please notice that
generator control is HGM6120U,HGM6120U and HGM6120UC own
|
| same function except
RS485 port. |
| Note1: HGM6110UC/6120UC has RS485 port,
HGM6110U/6120U without
RS485. |
| Note2: HGM6110UC/6120UC is taken as an example
to describe in folowing listing |
| 1.HGM6120U/6120UC:
Based on HGM6110U/6110UC, it adds mains AC monitoring and |
| mains/generator automatic switching control
(AMF), especially suitable for the automation |
| system composed by mains and genset. |
| 2.HGM6100U series
automatic controller, integrating digital, intelligent and network
techniques, |
| is used for automatic control and monitoring
system of genset. |
| 3.It can carry out
functions of automatic start/stop, data measurement, alarm protection
and |
| three “remote” (remote control, remote measure
and remote communication) |
| 4.The controller
uses LCD display, optional display interface including Chinese, English,
Spanish |
| and Russian with easy and reliable operation. |
 |
| Feature
|
| 1.HGM6100U series automatic controller uses
micro-processing technique which can achieve |
| precision measurement, value adjustment, timing
and threshold setting etc.. |
| 2.All the parameters can be configured from
front panel to adjust via PC. |
| 3.It can be widely used in all types of
automatic control system for its compact structure. |
| simple connections and high reliability. |
| 4.Acrylic screen, improved wearable and scratch
resistance property. |
| 5.Silica-gel panel and keys can well adapt to
higher and lower temperature. |
| 6.Adapt to 3P4W, 3P3W, 1P2W and 2P3W
(120V/240V), 50Hz/60Hz AC power system. |
| 7.Can measure and display 3 phase voltage, 3
phase current, frequency, power parameter of |
| mains/gens. |
| 8.Mains have functions of over/under voltage
and lack of phase; Gens have functions of |
| over/under voltage, over/under frequency and
over current. |
| 9.Precision measure and display of parameters
about engine. |
| 10.Control protection: Automatic start/stop of
genset, load transfer (ATS control) and perfect |
| failure display and protection. |
| 11.With ETS, idle speed control, pre-heat
control, speed droop/raising control, all of them are |
| relay output. |
| 12.Parameter setting: Allow user to modify
setting and store them in internal FLASH memory. |
| The parameters cannot be lost even when power
off. All of parameters can be set not only from |
| the front panel, but also use programmable
interface to adjust them via PC. |
| 13.Multi sensors of temperature, pressure and
fuel level can be used directly, parameters can be |
| defined by user. |
| 14.Multi conditions of crank disconnect (speed
sensor, oil pressure, generator) can be selected |
| 15.Power supply range: (8~35)VDC, accommodating
to different starting battery volts. |
| 16.All parameters use digital modulation,
instead of analog modulation using conventional |
| potentiometer, having improved reliability and
stability. |
| 17.Add rubber gasket between shell and
controller screen, the waterproof can reach IP55 |
| 18.Controller is fixed by metal fixing clips. |
| 19.Modular design, flame-retardant ABS shell,
embedded mounting, compact structure and easy |
| installation. |
 |
 |