110v Automatic Wire Stripper Machine
https://buyyou.net/cbe/data/prd/153/088/1.jpg

Introduction

　

This machine is suitable for various types of wire, wire, silk, wrapped in aluminum. Size can be followed by line and hole. Waste wire and cable capable of stripping diameter (1-42mm).
　

Parameters

  • Voltage:110V (If you need 220V,  please contact us)
  • Rated Power: 1500W
https://buyyou.net/cbe/data/prd/153/088/2.jpg

Operations

1. Push the Switch up to  turn  the Motor ON, Check whether the machine work well. Make sure There  are no  people on the output side of the machine. Comparing the   cables/wires’ diameters with the feeding holes on the machine, feeding the   cables/wires one piece at one time. Before feeding the  cables/wires, please cut off the head of the cables/wires, to avoid gaps  caused to the blades.
2. On the output side, if the cuts on the cables/wires are too deep, please check below points:
①Please adjust the handles on the input side, screw down or loose them. (M12 handles)
②Check whether the cables/wires on the right position as you feeding them.
③Make sure the blades are sharp, if not, polish them with the oil stone
3. On the output side, if see the plastic (PVC) has been stripped, but the copper wires can not been disgorged, please check below 4 points:
①Check whether the springs are loose, if yes, screw down to make them tighten
②The diameter of the cables/wires are too small, please adjust the space between the two axises to 0.3-0.6mm.
③If the cables/wires you want to strip are hot, also can not get the copper wires stripped out.
4. If the cables/wires were Blocked in the axises,  please check below points:
①check if the V-belts are loose.
②If the springs on the press wheels are too tight, loose them.
③There are too much oil on the cables/wires, please wipe it (make sure  the  machine is turned off when you wipe the axises)

Blades adjuster

A: Diameter 1-5mm   cables/wires’ feeding hole 
B: Diameter 5-10mm cables/wires’ feeding hole
C: Diameter 10-15mm cables/wires’ feeding hole
D: Diameter 15-20mm cables/wires’ feeding hole
E: Diameter 20-25mm cables/wires’ feeding hole
F: Diameter 25-30mm cables/wires’ feeding hole
G: Diameter 30-42mm cables/wires’ feeding hole

Notice

Make sure the  cables/wires’  diameter are similar with the feeding holes ,large  cables/wires in large  feeding holes, small cables/wires in small feeding holes, flat Cables/wires in flat feeding holes.
https://buyyou.net/cbe/data/prd/153/088/12.jpg

　

Item included:

110v  Automatic Wire Stripper Machine  (153088)

　
Item## Description QTY Unit
153088 110v Automatic Wire Stripper  Machine 1 set
DataCaciques