Pizza Cone Forming Machine 110v |
|||
|
|||
Introduction |
|||
production: The
switch can control the production of the cone of the conical pizza. |
Parameters |
||
Voltage | 110V | ||
Power | 2.8kw | ||
The quantity of molds | 4 | ||
Machine Size | 21.65*17.72*42.13inch | ||
Weight | 62.9kg/138.6lbs | ||
Cone Size: | 2.76”*6.69”*0.19”/ 7*17*0.5cm | ||
The quantity of molds | 0- 300 degree centigrade | ||
Display |
|||
How to use |
|||
(1) Check and clean up the machine to
make sure there are no foreign bodies before use. (2) On 110v power supply, close the machine power master switch on the right side. (3) Turn right to stop switch, the power indicator (red) on. (4) Adjust the thermostat preset temperature on the mould. (5) Press the down key to test the machine. In order to adjust the pizza crust thickness, let the above mold down to the bottom until touch the limit switch on the left side and stop the machine. (6) Display time controller shows the molding time. The above mold automatically rise, back to the original position. After checked above, put kneaded dough evenly into the below mold, start the machine to begin pizza cone production. Note: Only when the upper mold is fully raised can the lower mold be opened to remove the cone, be careful not to get burned,If there are some questions using the machine, please contact us. |
|||
Detail Display |
|||
|
|||
|
|
||
About wiring |
|||
NOTE:Due to excessive current, the machine does not have a plug and needs to be connected to a circuit breaker. Please seek professional electrician for operation. |
|||
Application |
|||
|
|||
For
better results, it is recommended to buy with rotational pizza oven
Rotational Pizza Oven
110V(153202)
|
|||
Item included |
|||
Pizza Cone Spiral Shape Forming Machine 110v(153216) |