 |
||||||||||||||||||||
|
110V Automatic PVC Banner Welder Black |
||||||||||||||||||||
|
|
||||||||||||||||||||
|
||||||||||||||||||||
 |
||||||||||||||||||||
| Operation | ||||||||||||||||||||
|
1.First, make the picture smooth and tight, take joiner to accurate (about 2-4cm), fixed edges with tape or glue on the ground. 2.Set temperature: connect power, turn on the temperature knob (the golden knob) until it click, and then press▲(▲for up ▼for down). In general, the temperature is between 350-400℃，Or to know it the temperature is ok, we can taking some waste banners to aligned nozzle to test, If it can be melted immediately, This temperature is the one you need and to set. if not strong just increase temperature, if too hot, reduce temperature. check photo below: 3.Set wind speed: in general, we put wind speed to the largest. so just put wind speed to the Maximum is ok. 4.Set walking speed: Then turn on waling knob to adjust the speed, generally marked on the knob points to the location between 3 from 4. 5.Start welding: when actual temperature of the display screen reaches temperature that you set, we can begin to weld. put operation handrail (at end of the machine) to left, machine begin to work automatically. 6.During welding, let hot air nozzle between two overlap pieces. And be make sure hot air nozzle and Rubber wheel walk in straight line. if not, please adjust by hand. check photo: 7.Finish welding: turn the walking handrail to the right ,machine stop walk, then turn off the yellow button (temperature knob), but before cut off the power, please wait until actual temperature below 50 ℃，then we can cut of the main power, or it would be damage heat system. 8. Don't use it in rainy day,the workplace should be dry, flat and safety of fire. The machine should have technical person to operate, it is forbid that someone use it without specific knowledge. Working voltage：110V Strictly prohibited without permission disassemble, you should be responsible the result yourself. Please pay attention: In order to keep heat element, we add Automatic Dormancy function, it means if not using welder over 10 minutes, machine would be enter dormancy state. if want it reback to work, just press the ‘Reset’ button or put the operation handle to right is ok, but it nee ds 1 minute to raise the temperature, so we need to wait. |
||||||||||||||||||||
|
||||||||||||||||||||
| Item Include(154038) | ||||||||||||||||||||
|
