1. To charge the unit, use the
included Linher electronic charger:
a. Unscrew the screw and remove the end couver.
b. Slide the rechargeable battery pack out or leave there.
c. Plug the charge pin into the pack, then connect the AC power.
d. The RED charger light is on, indicating that charging is in progress.
e. Wait 8-10 hours or until the RED charger light turns GREEN.
f. Replace the pack; replace the end cover
and the screw.
2. If unit is not used for extended periods of time, remove the battery pack for
storage.
3. If the unit is dropped in standing water, remove the battery pack, to ensure
there is on water inside. If water is present, allow battery to air-dry for 24
hours. Ensure there is no moisture in the battery pack or handle unit before
using or storing.
4. When the prod is not in use, attach the safety clip to the trigger button to
avoid accidental discharge.
5. Always us a shaft length that allows you to
maintain a safe working distance form all livestock.
6. To attach the shaft to handle unit, place shaft onto handle and tighten white
collarnut.
7. To remove the motor, unscrew the brass nut and remove the end cover, slide
the battery case out and then alide the motor out. If the motor won’t come out.
You should remove the shaft and push the motor out from the shaft end of the
handle. Then you can replace the motor.
8. To use the prod, remove the safety clip from
the trigger button and place the wrist strap around your wrist. Press the
trigger and place the contact points of the prod on the rear of the animal. For
baest results, simply press, touch and release.
9. Operators are encouraged to minimize use of stock prod.
10. Use caution when using the Linher prod on wet animals because of potential
increase in intensity.
