| Parameters:
1. Suction: 100-120 N / cm2 2. Size: 6*18 inch |
Method of use：
Put the workpiece on the suction table, and then insert the wrench into
the shaft hole to turn clockwise180°, the workpiece can be sucked for
processing.
The workpiece is completed, the wrench can be inserted into the shaft
hole to turn counterclockwise 180 °, you can remove the workpiece
Maintenance：
Sucker should be wiped clean before use to avoid scratching the surface,
after using, the surface should be coated with oil to prevent corrosion.
Use of ambient temperature: -40 ℃ -50 ℃.
Do not knock, to prevent magnetic reduction.
Strong dense pole permanent magnet sucker is for surface grinder, sparks
machine, WEDM.
Very fine spacing, uniform magnetic distribution, particularly for
processing small thin parts.
Worktable precision no change while magnetizing and demagnetizing.
Panel with special treatment, no leakage, to prevent corrosion of
cutting fluid. To prolong service life of the disk, it can be placed on
the cutting fluid for storage. Six-surface fine grinding processing, the
sucker can be used in vertical direction on the wire cutting machine
cutting.
High-performance magnetic steel disk, with suction, almost no remanence.