SWG-22A Manual Pipe Bending Machine

Model:SWG-22A

Setting up

Put the crossbar on the housing, so that the sliding pieces for the desired pipe size are positioned towards the dented rod.

The sliding pieces are marked with the various pipe sizes. Fasten the crossbar with the wing screw.

Choose the correct former and put it on the dented rod. Pull the feed lever in indicated direction and push the former and dented rod to the handle release feed lever.

SWG-22A

1/4'', 5/16'', 3/8'', 1/2'', 5/8'', 3/4'', 7/8''(6mm-22mm)

Operation

Turn the sliding pieces as such that the related radius of the indicated pipe size is positioned opposite the former.

Put the pipe in between the former and sliding pieces. Press feed lever a few times in indicated direction(upword),

and drive the former as far as desired. Pull the feed lever downward and push the former if necessary with

the bent pipe backwards, take the pipe out.

SWG-22A Manual Pipe Bending Machine(220287)