This type electric hot knife is a general purpose hot knife cutter used for hot cutting and melting woven and knitted synthetic materials to prevent fraying. Cuts all types of synthetics such as webbing, braid, elastics, strapping, cord, ribbon, hook & loop, and rope.

1. The towing strap cutter is a general purpose hot knife cutter used for hot cutting and melting woven and knitted synthetic materials to prevent fraying.
2. Cuts all types of synthetics such as webbing, braid, elastics, strapping, cord, ribbon, hook & loop, and rope.
3. It can cut and seal the fabric at the same time.
4. According to the fabric's material, thickness and diameter, you can adjust the temperature to prevent from being burnt.

Power supply: AC 220V/50HZ
Weight: 5.5 kg
Power: MAX.600W
Preheating time: 8mins
Length of wire: 3m
Cutting length: MAX.300mm

Cautions before operation
1 Check the power supply
Webbing cutter is powered by 220V（±10%）,50Hz（±5%）, the fuse wire is fixed at the back of the housing, please update the fuse if needed:
Screw down the fuse cape
Fix the fuse 5A 250V.
Screw up the fuse cape.
2 Fix the handle on the to aluminium plate
Operation
1 Plug the machine, turn it on.
2 Adjust the knob at (6~8)
3 Pre-heating 6mins.
4?Put the cutting material under the webbing cutter blade, press the blade carefully
by handle. Check the cutting edge, then decide if need to adjust the cutting
temperature till cutting edge is fine.
5 Cutting works start.
6 when?cutting, after 2-3 seconds, pull the webbing slightly, depart the webbing, so as to avoid the cutting mess.

Caution
1 ?This type electric hot knife ?is a high temperature cutting device, it is recommended to wear gloves. Don not touch the device, except handle and control panel. Touching blade is prohibitted.
2 ?Clear the blade by copper wire brush.
3 ?Make sure plug off the device, when not or after working.